Delete a company

Delete a company that was registered by mistake, such as a test company or a duplicate, after removing it from projects and removing its persons.

You can delete companies registered by mistake, test companies from setup or duplicates. It is usually best to keep a company you have worked with. Then projects and products that refer to it stay as they are.

Before you delete

You cannot delete a company that is added to a project or has persons. Open the company and check its tabs:

Tab What to do
Projects Shows the projects the company is added to. Remove the company on the Company tab in each project. See Companies and persons in a project.
Persons Shows the company's contact persons. Remove them from the company. The persons are not deleted. See Persons.

Note: Before you remove the company from a project, pick someone else in place of its persons. Triark EDM replaces the company's persons with Unknown in the project. This applies wherever they are used, for example as responsible for a document or a workflow task.

Delete a company

You need the Admin user type, or Delete on Company under System Access. See Users.

  1. Turn on edit mode (the switch top right, or F2). If edit mode is off, Triark EDM does not show the Delete button.
  2. Click Companies in the left menu.
  3. Click the company you want to delete to select the row.
  4. Click Delete above the list.
  5. Click Confirm.

You delete one company at a time. A deletion is permanent. You cannot undo it.

Tip: If you only want to stop the use of a company, give it a status that says so. Do not delete the company. See Companies.

Did not find the answer?

Support is open 08:00–16:00 Norwegian time (CET/CEST).